User guide

3-34 July 2007 - Issue 1.0 Wave Phone User Guide
Chapter 3 - Using Wave Phone Features Hold
Using a Headset [D] / [A]
When using a headset on digital or analog phones, you can adjust the volume
by using the Volume buttons on the front of the phone. In addition to begin or
end calls, you will need to use the Speaker buttons with the headset plugged
into the jack.
HOLD
You can place a call on hold to keep the other party connected while you hang
up the handset or use other phone features.
Placing a Call on Hold [ALL]
For SIP Phones
To place a call on hold:
Press Hold ( on models 9112i and 9133i, or the key labeled Hold
onModels 480i/480CT.
The LED flashes next to the line key with a call on hold.
You can hang up the handset or use other phone features.
If you leave the call on hold for too long, your phone rings back to
remind you.
Note: The FLASH key can be used to place calls on temporary hold.
To reconnect to a call on hold:
Press the key corresponding to the line at which the call was placed on
hold.
Using the Reconnect Soft Key (Model 480i/480CT only)
Use this soft key to reconnect to a call that is on hold or parked.
Using the Toggle Soft Key (Model 480i/480CT only)
Use this soft key when it appears on the display to switch between two calls in
progress by pressing the appropriate line appearance keys alternately.