User guide

Wave Phone User Guide July 2007 - Issue 1.0 3-23
Chapter 3 - Using Wave Phone Features Conference Calls
To make a conference call with feature codes:
1. During a call, press FLASH to place the other party on hold.
2. Listen for dial tone, then dial the extension of the third party.
3. When the third party answers, press FLASH and dial *71 to connect the
calls.
• If a party is not available, press FLASH and dial *72 to reconnect to
the first party.
• If a party’s Voice Mail answers, or the party does not want to join the
conference, press End Call.
• For Models 480i/480CT, press Goodbye ( to drop the call and
rejoin the first party.
4. Press FLASH again to place the conference call on hold and to add a
fourth party.
5. Press FLASH and Dial *71 to connect the fourth party to the conference.
To disconnect from a conference call:
Hang up the handset, or press End Call
• For Models 480i/480CT, press Goodbye ( or use the “Drop”
softkey.
For DIGITAL Phones
Since all Wave Digital phones have a hard-coded TRANS/CONF key, a
programmed Conference feature key is not required. However, such a feature
key is supported for backwards compatibility.
The functionality between such a key and the TRANS/CONF key is identical.
Therefore, you can use the steps below substituting the feature key for the
TRANS/CONF key.
To set up a Conference:
1. During a call, press TRANS/CONF to place the other party on hold.
The HOLD key LED flashes red, and the line key LED is yellow.
2. Listen for dial tone, then dial the number of the next party.
3. When the other party answers, press TRANS/CONF again to connect
the calls.
• The number of parties in the current conference call will appear on
the display.
• If a party is not available, press TAP, or press the key corresponding
to the initial call to reconnect to the first party.
4. Press TRANS/CONF again to place the conference call on hold and add
a fourth party.
5. Repeat steps 2 through 4 to add additional parties.*
6. Complete the conference by pressing TRANS/CONF.