User guide

3-4 July 2007 - Issue 1.0 Wave Phone User Guide
Chapter 3 - Using Wave Phone Features Call Park
CALL PARK
Use Call Park to place a call on hold for retrieval from any phone on the
system.
Directed Park [ALL]
Directed Park allows you to park a call on another line. A specific extension
number might be programmed on your Directed Park key to allow you to
always park a call on a specific line.
For DIGITAL Phones
To Direct Park a call:
1. While on an active call, press Directed Park.
If you do not have a programmed Directed Park key, press FLASH, then
*66 to park a call.
2. Enter an extension number, if necessary.
3. Listen for two short beeps, and hang up.
If the key is configured to display the status of the parked call, the green
LED will flash until the call is unparked. If the call does not get answered,
you can retrieve the call by pressing the Directed Park key. You can use
the key to park another call on another line even if the green LED is
flashing.
You can only park one call on any given line. Any other phones that have
a Directed Park key targeted at the same line where the call was parked,
and are configured to show status, will flash red, indicating that there is a
call already parked on the target line.
If you leave a call parked for a long period of time, your phone rings
back, and
PARK is displayed.
To retrieve a direct park call:
Press Directed Park.
If the phone does not have a Directed Park key, dial *65 and the target
extension number.
You can also use the Self Park key (if available), and the target extension
number.
Note: The Direct Park key will not work if it has been pre-programmed for an
extension other than the target extension. Contact your Wave system
administrator for more information.