Installation guide

Trunk timing values 34-10
Chapter 34: Trunk Settings
Wave Global Administrator Guide
The following table describes the different types of outbound analog trunk timers for loop start
and ground start signaling types.
Outbound analog trunk timers (loop start and ground start)
Display Name Description Default Value
(msec)
Error Duration
Length of time-out after an error before the trunk
is put back into service
30000
Flash Duration
Length of hook flash sent to the far end. 500
Wait Start Signal
Maximum wait for tip ground before declaring a
glare situation
5000
Disconnect
Maximum wait for far-end disconnect after near
end disconnects an outbound call before treating
the situation as an error
2000
Wait Dial
Delay before dial after tip ground and dial tone
detected
500
DTMF Duration
Duration of DTMF tone on and off 100
Release 2.0
September 2010