Installation guide

Trunk timing values 34-8
Chapter 34: Trunk Settings
Wave Global Administrator Guide
The following table describes the different types of outbound trunk timers for signaling type
ground start.
The following table describes the outbound trunk timers for ISDN PRI.
Outbound T-1 trunk timers (ground start)
Display Name Description Default Value
(msec)
Error Duration
Length of time-out after an error before the
channel is put back in service
30000
Validate Start
Signal
Time to wait for dial tone before declaring a
glare situation
4000
Wait Start Signal
Maximum wait for tip ground before declaring a
glare situation
500
Far-End
Disconnect
Minimum length of incoming on-hook when
far-end disconnects first
250
Wait Dial
Delay before dial after tip ground and dial tone
detected
10
DTMF Duration
Duration of DTMF tone on and off 100
Inbound T-1 trunk timers (ISDN PRI)
Display Name Description Default Value
(msec)
Alert/Connect
Timeout
Milliseconds after an offhook before an
incoming call is processed
0
Inter-Digit
Maximum wait for next digit 8000
Maximum wait for
Caller ID
Milliseconds after the first ring to wait for Caller
ID
2000
Release 2.0
September 2010