Installation guide

T-1 Private SNMP agent 32-60
Chapter 32: SNMP Agents
Wave Global Administrator Guide
T-1 Private Agent Traps
The T-1 private agent also generates the traps and trap notifications to any connected manager
under the line error conditions described in the following table.
.
vdsx1channelLocal
SubAddress
R The local sub address of a connected
call on this channel.If the number is
not available, then it will have a
length of zero
String
vdsx1channelChange
Pending
R Indicates that a change to the channel
values have been made to the
registry.The interpretation of the
values is:
• 1 = change made to the registry,
but not incorporated in the
device yet.
•
0 = the device changes the value
to 0 from 1, after it incorporates
the value from registry.
Integer
0-1
T-1 Private SNMP agent - Traps
1
vdsx1TrunkRedClear This notification is sent when the specific trunk
RED alarm condition clears.
vdsx1TrunkIdentifier
vdsx1cardSlotNumber
vdsx1TrunkDeviceNumber
vdsx1TrunkIndex
2
vdsx1TrunkRed This notification is sent when the specific trunk
goes into the RED alarm situation. Red alarm
condition signifies LOS (Loss of Signal) failure,
i.e. the receiver sees no positive or negative
pulses.
vdsx1TrunkIdentifier
vdsx1cardSlotNumber
vdsx1TrunkDeviceNumber
vdsx1TrunkIndex
3
vdsx1TrunkYellowClear This notification is sent when the specific trunk
YELLOW alarm condition clears.
vdsx1TrunkIdentifier
vdsx1cardSlotNumber
vdsx1TrunkDeviceNumber
vdsx1TrunkIndex
T-1 Private SNMP agent - Channel Table
MIB Variable Access Definition Syntax Value
Release 2.0
September 2010