Installation guide

T-1 Private SNMP agent 32-51
Chapter 32: SNMP Agents
Wave Global Administrator Guide
T-1 Private SNMP agent
The T-1 Private SNMP agent is based on the VerticalCommunications’ private extension MIB
to RFC 1406, and is used to manage the T-1 physical interface, analog channels, and the
Integrated Services Card trunk interface. This extension MIB defines additional variables which
facilitate the management of the Vertical Wave T-1 modules.
The Private MIB (t1_private.mib) is organized into three tables:
• Card Table. Contains status information about each Wave T-1 module. There is one row
in the table for each module.
• Trunk Table. Defines configuration and status information for each trunk on each T-1
module. There is one entry in this table for each trunk of each module.
• Channel Table. Contains generic configuration, status and statistical information about
each channel of each trunk.
Card Table
Each entry in the Card Table describes the read-only status of a T-1 module in the Wave system,
for example, the module type (T-1 module, analog trunk module, Integrated Services Card
(vdsx1CardType)), the module slot number (vdsx1CardSlotNumber), the module ISA address
(vdsx1CardISAAddress).
T-1 Private SNMP agent - Card Table
MIB Variable Access Definition Syntax Value
vdsx1cardSlotNumber
R Physical slot in the system in
which the card is installed
Integer 1-14
vdsx1cardType
R Vertical’s card type Integer 1 = cardTYPE-DUAL-T1
3 = cardTYPE-8-TRUNK
4 = cardTYPE-RESOURCE1
13 = cardTYPE-8-CHANNEL-DID
100 =
cardTYPE-NOT-CONFIGURED
vdsx1cardDescr
R Vertical card identification
number
Integer
0-255
vdsx1cardRevision
R Vertical card revision level Integer
0-255
Release 2.0
September 2010