Installation guide

Self Test Daemon (STD) SNMP agent 32-48
Chapter 32: SNMP Agents
Wave Global Administrator Guide
• If success • stdRestoreComplete trap is sent
• If failed • stdRestoreError trap is sent
•STD quits
STD SNMP agent - Traps
26
stdCompFailedToStart This trap is generated when a component fails to
start during initial start up. The Self Test Daemon
will attempt to restart this component five times
(once each minute), after which it gives up.
sysCurrentVersion
compName
27
stdCompAttemptRestart This trap is generated when the Self Test
Daemon attempts to restart a component.
sysCurrentVersion
compName
28
stdCompFailedToReStart This trap is generated when a n attempt to restart
a component fails.
sysCurrentVersion
compName
29
stdCompRestartComplete This trap is generated when a component is
restarted successfully.
sysCurrentVersion
compName
30
stdUpgradeStarted This trap is generated when an Wave upgrade is
started.
sysCurrentVersion
31
stdUnpackingFiles This trap is generated when unpacking of the
generated CAB files starts
sysCurrentVersion
32
stdUnpackingComplete This trap is generated when unpacking of the
upgraded CAB file is complete.
sysCurrentVersion
33
stdUpgradeBeingApplied This trap is generated when an Wave upgrade is
about to be applied. This is done after the CAB
file is unpacked and a system reboot is done.
sysCurrentVersion
34
stdUpgradeInProgress This trap is generated when an Wave upgrade
process is under way.
sysCurrentVersion
35
stdUpgradeComplete This trap is generated when an Wave upgrade is
successfully completed.
sysCurrentVersion
36
stdUpgradeError This trap is generated when an Wave upgrade
attempt fails. A Restore operation would be done
immediately.
sysCurrentVersion
STD SNMP agent - Upgrade and Restore stages
Release 2.0
September 2010