Installation guide

Self Test Daemon (STD) SNMP agent 32-44
Chapter 32: SNMP Agents
Wave Global Administrator Guide
Self Test Daemon (STD) SNMP agent
The Self Test Daemon SNMP agent is responsible for showing status and control information
for Vertical Communications’ Self Test Daemon (STD). The Self Test Daemon is responsible
for starting and monitoring each Wave component (executable, service, and drivers). The status
of each component (started, stopped, paused, disabled, etc.) as well as the status of the system
as a whole is made available.
In addition, since the Self Test Daemon controls the Upgrade and Restore process, this agent
generates appropriate traps to notify the various stages of the Upgrade and the Restore (in case
the upgrade is unsuccessful) process. For detailed information about each of these traps, see the
table in is available in “STD SNMP Agent Traps” on page 32-47The STD MIB is structured
into two groups, the System Group and the Component Group:
Group Description Tables contained
System Group
Describes status information about the Wave
system as a whole.
None.
Component Group
Contains status information of each
component (executable, service, or driver)
within the system.
STDComponentTable
Release 2.0
September 2010