Installation guide

Station Private SNMP agent 32-35
Chapter 32: SNMP Agents
Wave Global Administrator Guide
Station Private SNMP agent
The Station Private SNMP agent is used to monitor, configure and control all station devices
within the Wave system. Additionally, this agent can be used to configure the First Digit Table
(which contains settings for each digit that is dialed as the first digit), as well as to configure an
interface with an external voicemail system.
This MIB is structured into four groups:
•
Common Group. Contains status and configuration information that are common to all
Station devices within the system.
•
Station Card Group. Contains status, control, and configuration information about all
cards containing station devices within the system. This information is arranged into
three tables: the Card Table, the Device Table, and the Channel Table.
•
Digit Table Group. Contains configuration information of digits that can be dialed.
Currently this group contains just one table, the First Digit Table, which contains settings
for each digit (0-9) dialed as the first digit.
•
External Voicemail System Group. Contains configuration information used to
interface with an external voicemail system. Currently there is one subgroup: the
ATT_System_25 subgroup.
Common Group
Station Private SNMP agent - Common Group
MIB Variable Access Definition Syntax Value
vStationFirstDigitTimeout
R Specifies the maximum number of seconds to
wait for the first digit.
Integer
vStationDigitTimeout
R Specifies the maximum number of seconds to
wait between digits.
Integer
vStationOffHookTimeout
R Specifies the maximum number of seconds to
wait for the user to hang up after a call
disconnects or the user executes an invalid
operation. Howler tone is applied at time-out.
Integer
Release 2.0
September 2010