Installation guide

Repeater Private agent 32-26
Chapter 32: SNMP Agents
Wave Global Administrator Guide
The Info Table contains status information about each repeater hub within the system.
In Wave implementation, a Group is the same as a separate repeater, so the information in the
Info Table and the Group Table complement each other. These tables have been kept separate
in keeping with the MIB structure in RFC 2108.
Table 0-5 Info table, Repeater hub agent
MIB Variable Access Definition Syntax Value
vrptrInfoId
R Identifies the repeater for which
this entry contains information.
Integer
1-2147483647
vrptrInfoRptrType
R Identifies the CSMA/CD repeater
type. The value of 5
(tenMbOrOnehundredMb) is a
Vertical Communications
extension specifying 10/100 Mb
repeater which contains mixed 10
Mb and 100 Mb ports.
Integer 1 = Other
2 = tenMb
3 = onehundredMbClassI
4 = onehundredMbClassII
5 =
tenMbOrOnehundredMb
vrptrInfoOperStatus
R Indicates the operational state of
the repeater.
Integer 1 = Other
2 = OK
3 = Failure
vrptrInfoReset
R Setting this object to reset (2)
causes a transition to the START
state. Setting to noReset (
1) has no
effect.
Integer
1 = NoReset
2 = Reset
vrptrInfoPartitionedPorts
R Returns the number of ports in the
repeater that are in the
autoPartitioned state.
Integer
0-24
vrptrInfoLastChange
R The values of syUpTime when any
of the following conditions
occurred:
• Agent cold or warm started
• This instance of repeater was
created
• A change in rptrInfoOperSta-
tus
• Ports were added or removed
• Any of the counters in this
repeater had a discontinuity
Integer
Release 2.0
September 2010