Installation guide

Repeater Private agent 32-25
Chapter 32: SNMP Agents
Wave Global Administrator Guide
vrptrPortAutoPartitionState
R This flag indicates whether the port
is currently partitioned by the
repeater’s auto-partition
protection.
Integer 1 = notAutoPartitioned
2 = autoPartitioned
vrptrPortOperStatus
R This object indicates the port’s
operational status.
Integer 1 = Operational
2 = NotOperational
3 = NotPresent
vrptrPortRptrId
R Identifies the repeater to which this
port belongs.
Integer
1-2147483647
vrptrPortLinkState
R Specifies whether there is a link on
this port or not.
Integer 1 = link
2 = noLink
vrptrPortSpeed
R Specifies the Ethernet speed of this
particular port.
Integer 1 = unknown
2 = 10Mbps
3 = 100Mbps
vrptrPortSpeedSelect
R Indicates the selection used by the
port for negotiating the Ethernet
speed. If automatic is selected, the
highest supported speed will be
negotiated.
Integer 1 = speed-select-auto
2 = speed-select-10
3 = speed-select-100
vrptrPortDuplex
R Indicates the duplex of the Ethernet
port
Integer 1 = unknown
2 = half
3 = full
vrptrPortDuplexSelect
R Indicates the selection used by the
port for negotiating the Ethernet
duplex. If automatic is selected, the
best supported duplex will be
negotiated.
Integer
1 = duplex-select-auto
2 = duplex-select-half
3 = duplex-select-full
vrptrPortPolarity
R Indicates the polarity of the
Ethernet cable. If the polarity is
crossed, the repeater may
compensate for it, but it indicates a
wiring problem with the attached
Ethernet device.
Integer
1 = unknown
2 = straight
3 = crossed
Table 0-4 Port table, Repeater hub agent (continued)
MIB Variable Access Definition Syntax Value
Release 2.0
September 2010