Installation guide

Repeater Private agent 32-24
Chapter 32: SNMP Agents
Wave Global Administrator Guide
The Port Table contains status information about each managed repeater port in the system, for
each repeater hub in the system. Examples of these are the administrative status of the port
(enabled, disabled (vrptrPortAdminStatus)), the operational status of the port (operational,
notPresent (vrptrPortOperStatus)).
vrptrGroupNetwork
AdapterNumber
R This object indicates the identification
number of the Wave network adapter
associated with the repeater, if any. This
value will be 0 if the repeated domain
number is unassociated or unknown.
Integer
1-255
vrptrGroupLedStatus
R This object indicates the status of the
card LEDs. The Led status is shown for
any card that has an Ethernet interface. A
status of unknown (1) indicates that the
LED status is not available from the
hardware. All 10Mb cards will return a
value of unknown for its LEDs since the
LED information for 10Mb cards are not
available. A status of none (2) indicates
neither the green nor the red LED is ON.
A status of greenRed (5) indicates that
both the green and the red LEDs are ON.
Integer
1 = unknown
2 = none
3 = green
4 = red
5 = greenRed
Table 0-4 Port table, Repeater hub agent
MIB Variable Access Definition Syntax Value
vrptrPortGroupIndex
R Identifies the group containing the
port for which this entry contains
information.
Integer
1-2147483647
vrptrPortIndex
R Identifies the port within the group
for which this entry contains
information. This identifies the
port independently from the
repeater it may be attached to.
Integer
1-2147483647
vrptrPortAdminStatus
R/W Setting this object to disabled(2)
disables the port.
Integer 1 = Enabled
2 = Disabled
Table 0-3 Group table, Repeater hub agent (continued)
MIB Variable Access Definition Syntax Value
Release 2.0
September 2010