Installation guide

SNMP agent and alarm configuration 32-2
Chapter 32: SNMP Agents
Wave Global Administrator Guide
SNMP agent and alarm configuration
Wave provides two panels for configuring and monitoring SNMP: the SNMP Configuration and
SNMP Alarms panels. The SNMP Configuration applet lets you configure trap destinations
from Wave agents, and permits the following functions:
• Define valid (up to seven) community strings
• Identify destination managers who will receive traps (notification about any unsolicited
events)
The SNMP Alarms applet lets you monitor current and review previous alarms. For further
information about using the SNMP Alarms and SNMP Configuration applets, see “Configuring
and using SNMP” on page 23-25.
Vertical Communications SNMP agents
The following SNMP agents are supported:
Environment. See page 32-3.
Event Log. See page 32-8.
Interfaces. See page 32-12.
IP Telephony. See page 32-14.
ISDN. See page 32-15.
Repeater Private. See page 32-22.
Station Private. See page 32-35.
Self Test Daemon (STD). See page 32-44.
T-1 Private. See page 32-51.
Release 2.0
September 2010