Installation guide

Automatic Line Selection 29-30
Chapter 29: Understanding Wave Call Routing
Wave Global Administrator Guide
Automatic Line Selection on Outside Line feature buttons
The examples that follow all use the same digital phone line feature button configuration shown
in Example 1, below.
• The first button is the primary line button configured for extension number 100.
• The second button, Line 1, is an outside line that is not configured for Automatic Line
Selection.
• The third button, Line 2, is an outside line that is configured for Automatic Line Selection
(ALS).
Example 1: Primary line in use
In the following diagram, In the following diagram, the primary line is in use.
Lifting the handset, pressing Speaker/Mute, or dialing the external access digit selects Line 2.
Pressing Auto Dial, Redial, or Flash produces no result. To select Line 1, press Line 1.
Example 2: Outside line without ALS ringing
In the following diagram, Line 1 is ringing.
Lifting the handset, or pressing Speaker/Mute gives you dial tone on extension 100. Pressing
Auto Dial, Redial, or Flash also selects extension 100. Dialing the external access digit selects
Line 2. To answer the call on Line 1, you must press Line 1.
100
Line 1
Line 2
Primary line
Outside line with ALS
Idle
In use
Ringing
LED states
Outside line
100
Line 1
Line 2
Primary line
Outside line with ALS
Idle
In use
Ringing
LED states
Outside line
Release 2.0
September 2010