Installation guide

Configuring WaveNet 25-14
Chapter 25: Connecting Wave Servers via WaveNet
WaveNet Administrator Guide
Configuring WaveNet
To configure WaveNet, you use the WaveNet Management applet, available on the Applications
tab of the Global Administrator Management Console.
This section describes how to do the following:
• Adding a Wave Server to the WaveNet network. See page 25-14.
• Testing connections between WaveNet nodes. See page 25-17.
• Publishing local users on remote nodes. See page 25-20.
• Viewing subscribed users. See page 25-23.
Adding a Wave Server to the WaveNet network
You can add your local Wave Server or any other Wave Server to the WaveNet network, or
create a new WaveNet network by adding each Wave Server.
To add a Wave Server to the WaveNet network, you add it to one other node according to the
following instructions. When a node is added to one node, it is automatically joined to all other
nodes that are already connected.
To add your Wave Server to the WaveNet network
1 If necessary, click the Applications tab of the Management Console.
2 Click the WaveNet Settings icon, located in the WaveNet section.
Click
Release 2.0
September 2010