Installation guide

Adding accounts and passwords 3-8
Chapter 3: Before You Begin
Wave Global Administrator Guide
Adding accounts and passwords
To secure your Wave system against unauthorized configuration, you must remove the default
account and replace it with a new account.
By default, only individuals with enterprise-level access can configure the Wave system using
the Management Console.
The Access Permissions applet contains a list of all the Management Console applets and the
access level required to use them. You can use the Access Permissions applet to change the level
of access granted to manager- and user-level accounts. For more information about configuring
access permissions, see page 3-9.
To replace the default Wave accounts
1 If necessary, click the Administration tab of the Management Console.
2 Click the Password Administration icon, located in the General Administration section.
The Password Administration applet opens.
3 Click
New to open the Add New User dialog.
The first user you create will be an enterprise-level user. Enterprise-level access is the most
comprehensive. It allows an administrator to perform all of the Wave administrative
functions, including changing and configuring access permissions. You will need at least
one account with enterprise-level access to configure everything in your Wave system.
4 Enter a
User Name for the account.
The user name can be up to 20 characters and can use any combination of alphanumeric
characters and exclamation points (!), underscores (_), and dashes (-). However, the first
character may not be a numeral.
5 Enter the user’s
Full Name.
The full name can be up to 32 characters and can use any combination of characters,
including spaces.
Click
Release 2.0
September 2010