Installation guide

Entering basic system information 3-5
Chapter 3: Before You Begin
Wave Global Administrator Guide
6 Enter the entire Serial Number of the Wave Server. The serial number is located on the side
of the chassis, and is in the following format, where AA is an alphabetical value and n is a
numerical value:
AAnnnnnnnnnn
7 If the
Locale setting is correct for your system, go to step 8. If not, select your locale from
the drop-down list.
When you change the
Locale setting, you are reminded that you may need to update any
area codes that you have already defined in the First Digit Table to reflect new area code
requirements for the selected locale.
For more about editing the First Digit Table, see “Setting the home area code” on page 7-5.
Caution: The Customize button allows you to customize the advanced settings for
the locale specified. The default advanced settings for a locale should work for you
unless you have a unique environment. These are expert settings that should not
be modified unless you are instructed to do so by your Vertical Technical Support
representative. For more about the advanced settings for a locale, see Chapter 33.
Click OK to continue.
8 Select the
Voice Mail System extension used to reach the voice mail hunt group. The
default is 550 (which is adequate for most systems) but you can map it to a different pilot
number (see “Configuring the VoiceMail extension” on page 7-7.)
9 Click
Apply to save your changes.
10 Click
Done to return to the Management Console.
Release 2.0
September 2010