Installation guide

Managing Wave system resources 23-42
Chapter 23: Continuing System Administration
Wave Global Administrator Guide
4 Restart the Wave Server.
5 If necessary, click the Administration tab of the Management Console.
6 Click the RAID 1 Configuration icon, located in the General Administration section.
7 Select
Action > All Tasks > Remove Mirror.
8 Select Disk 1, then click
Remove Mirror.
Note: No fault tolerance is available until a new mirror is established.
9 Re-establish fault tolerance (RAID-1). To do so:
a Shut down the Wave Server.
b Insert a new hard drive in slot B.
c Follow the instructions in “Mirroring your hard drive” on page 15-6.
Managing Wave system resources
Many Wave and third-party applications require system port DSP resources such as
TAPI/WAVE ports, Fax ports, and IP telephony ports. You manage system port DSP resources
via the Resource Management applet in the Global Administrator. The type and number of
system ports available on your Wave Server may vary depending on which cards and modules
that are installed. For information about the resources included on your Wave Server cards and
modules, refer to the Wave Server Hardware Reference Guide.
Caution: You must allocate an appropriate number of resources to cover your system
demand. If you under-allocate resources, calls may be lost or not handled as expected.
Click
Release 2.0
September 2010