Installation guide

Using Disk Management and configuring RAID 1 23-40
Chapter 23: Continuing System Administration
Wave Global Administrator Guide
Identifying RAID disk health
To determine the condition of a mirror set, periodically check the status bar in the Disk
Management application. Disk Management displays information about the mirror in the Status
column in the Volume List. The following table describes each status type that could be
displayed in the Disk Management Status column. If a partition in the set is damaged or loses
synchronization with the other partition, FAILED or FAILED REDUNDANCY is displayed.
To check the status of a RAID disk
1 If necessary, click the Administration tab of the Management Console.
2 Click the RAID 1 Configuration icon, located in the General Administration section.
Status Description
FAILED
Displayed when a volume cannot be started automatically or the disk is
damaged.
FAILED REDUNDANCY
Displayed when one of the mirrored disks is not online.
HEALTHY
Status if the mirror set is healthy.
REGENERATING
Displayed while Wave is generating the mirror set.
RESYNCHING
Displayed while Wave is establishing the mirror.
Click
Release 2.0
September 2010