Installation guide

Using Disk Management and configuring RAID 1 23-39
Chapter 23: Continuing System Administration
Wave Global Administrator Guide
8 Click Yes.
The drive letter will be removed, the partition will be cleared, and a new color will indicate
free space (the default is striped).
9 Repeat steps 6 to 8 for each partition.
A hard drive should be free and clear of partitions before it is used for mirroring.
Cloning a hard drive using RAID
Cloning a hard drive, using RAID, is an effective way to create a duplicate of Wave.
To clone a hard drive
1 Create a mirror of the hard drive using the instructions in “Mirroring your hard drive” on
page 15-6.
2 Shut down the Wave Server.
3 Remove the hard drive from Slot B.
4 Restart the Wave Server.
5 If necessary, click the Administration tab of the Management Console.
6 Click the RAID 1 Configuration icon, located in the General Administration section.
7 Select
Action > All Tasks > Remove Mirror.
8 Select
Disk 1, then click Remove Mirror.
9 Shut down the Wave Server.
10 Insert a new hard drive and restart the Wave Server.
11 Establish the mirror between the two hard drives, using the instructions in “Mirroring your
hard drive” on page 15-6.
12 Install the hard drive you removed in another Wave Server.
You will need to assign new IP addresses and a new host name to the Wave Server housing the
cloned hard drive you removed from the original Wave Server.
Click
Release 2.0
September 2010