Installation guide

Using Disk Management and configuring RAID 1 23-38
Chapter 23: Continuing System Administration
Wave Global Administrator Guide
Using Disk Management and configuring RAID 1
You will typically access the Disk Management application using the RAID 1 Configuration
icon to determine the status of your Wave Server hard drives, mirror a new hard drive, or use a
mirrored hard drive to recover Wave after a failure. You can also mirror a hard drive as a method
of backing up your Wave configuration.
Clearing an old hard drive
To clear an old hard drive
1 Shut down the Wave Server.
2 Insert the old hard drive in slot B.
3 Restart the Wave Server.
4 If necessary, click the Administration tab of the Management Console.
5 Click the RAID 1 Configuration icon, located in the General Administration section.
6 Select a partition on Disk 1.
7 Choose
Action > All Tasks > Delete Volume.
Click
Release 2.0
September 2010