Installation guide

Configuring and using SNMP 23-29
Chapter 23: Continuing System Administration
Wave Global Administrator Guide
To add a trap destination
1 Choose a trap community name from the list.
2 Click
New under Trap Destination. The Trap Destination dialog opens.
3 Type the DNS host name of the Wave Server, and IP address of the trap destination, then
click
OK.
By default, the trap destination list includes localhost, which means that SNMP alarms will
be returned to the Wave Server you are configuring, and can be monitored via the SNMP
Alarms applet in the Management Console.
4 Repeat to add more trap destinations.
Client machines listed as trap destinations receive SNMP traps, which can be viewed from
the SNMP Alarms applet. All client destinations listed as trap destinations receive SNMP
traps from this Wave Server. The community name encoded in the trap message depends
on which community the trap destination belongs.
Configuring an SNMP trap filter
Using SNMP Filters, you can enable and disable specific groups (trap groups) of SNMP traps
to filter the traps for network monitoring tools.
To filter SNMP traps
1 If necessary, click the Administration tab of the Management Console.
2 Click the SNMP Configuration icon, located in the General Administration section.
Click
Release 2.0
September 2010