Installation guide

About the General Settings applet 3-2
Chapter 3: Before You Begin
Wave Global Administrator Guide
Note: Some of the Management Console applets display dialogs, warnings, and panels
automatically. If you have installed a browser pop-up blocker on your client PC, these pop-ups
may not appear. You can usually configure blocker software to allow pop-ups from specific
domains or IP addresses.
About the General Settings applet
You use the General Settings applet to set many system-wide settings for your Wave system.
The following list provides links to information about the tasks you can accomplish via the
various tabs in the General Settings applet.
System tab
•
Company Name, Main Number, Serial Number, Voice Mail System. See “Entering basic
system information” on page 3-4.
Note: During system installation, you will already have used the General Settings
applet to enter some basic system information, as described in Chapter 6 in the Wave
Server Installation Guide.
•
Locale. See “Setting and viewing system locale settings” on page 33-1.
•
Notify when less than ___ megabytes free. See “Setting the minimum free hard drive
space notification limit” on page 23-24.
•
Enable IMpulse Instant Message Service. See “Enabling the Instant Messaging server”
on page 16-42.
PBX tab
•
Enable Public Address. See “Enabling Public Address” on page 16-24.
•
Allow Automatic Phone Relocation. See “Enabling automatic phone relocation” on page
16-25.
•
Enable DSS/BLF updates when the user’s phone is active on any line. See “Enabling
DSS/BLF updates when the user’s phone is active on any line” on page 16-27.
•
Music On Hold. See “Configuring Music On Hold” on page 16-16.
•
External Caller ID. See “Configuring system-wide Caller ID settings” on page 16-11.
•
Night Answer Service. See “Configuring Night Answer” on page 16-29.
•
Fax Redirect Service. See “Configuring Fax Redirect” on page 16-15.
Release 2.0
September 2010