Installation guide

Configuring and using SNMP 23-27
Chapter 23: Continuing System Administration
Wave Global Administrator Guide
Configuring SNMP agents
You will typically access the SNMP Configuration applet to configure community names, trap
destinations, and specific management (host) destinations. Once SNMP agents are configured:
• Users can view SNMP traps from the Wave Server through the SNMP Alarms applet.
• Specified clients will be notified when SNMP traps occur.
To configure SNMP traps
1 If necessary, click the Administration tab of the Management Console.
2 Click the SNMP Configuration icon, located in the General Administration section.
3 Enter information about a contact person for this Wave Server.
You can enter a string of up to 255 characters in this field.
4 Enter information about the physical location of this Wave Server.
You can enter a string of up to 255 characters in this field.
Click
Release 2.0
September 2010