Installation guide

Configuring and using SNMP 23-25
Chapter 23: Continuing System Administration
Wave Global Administrator Guide
Configuring and using SNMP
Simple Network Management Protocol (SNMP) can be used to monitor and diagnose a Wave
Server, notifying you about any alarms and traps.
Using the SNMP Configuration applet, you can configure traps to notify specified clients about
any unsolicited events and you can set up several levels of security. Using the SNMP Alarms
applet, you can monitor current and review previous alarms. Wave supports the SNMP agents
listed in Chapter 32, SNMP Agents.
All Management Information Bases (MIBs) reside on the Wave Server in the
C:\Program
Files\SNMP\MIBs
directory.
For complete information about Wave SNMP agents and a list of other supported agents, see:
• SNMP terminology
• Configuring SNMP agents
• Configuring an SNMP trap filter
• Configuring SNMP security
• Configuring a contact
• Using SNMP alarms
Release 2.0
September 2010