Installation guide

Viewing the Fault Monitor Error Logs 23-20
Chapter 23: Continuing System Administration
Wave Global Administrator Guide
If a bluescreen event occurs, the operating system bluescreen data generated by the bluescreen
event is saved to the Fault Monitor bluescreen buffer. This data can be useful when
troubleshooting the bluescreen event. This buffer is 4 K bytes, and will either be empty or
contain the most recent bluescreen event. On each reboot, the entire contents of this buffer is
saved to the file
fmblu.*.txt, where the * represents the date and time the traces were saved.
You can find the fmblu.*.txt files on the Wave Server hard drive in the
C:/Program
Files/Wave/Logs
directory.
The contents of these buffers are lost if the Wave Server is powered off. In any situation where
the Wave is non-responsive and you wish to preserve the contents of these buffers for later
access, you should use the black reset button located on the Integrated Services Card. The Wave
Server should not be powered off so as to preserve the traces in the fault monitor buffers.
To view the Fault Monitor Error Logs
1 If necessary, click the Administration tab of the Management Console.
2 Click the General Settings icon, located in the General Administration section.
3 Select the Fault Monitor tab.
Click
Release 2.0
September 2010