Installation guide

Configuring network services and routing protocols 21-11
Chapter 21: Advanced Data Networking Configuration
Wave Global Administrator Guide
2 Right-click Static Routes in the IP Routing folder, and choose New Static Route. The Static
Route dialog opens.
3 Select an
Interface from the drop-down list.
4 Type a
Destination IP address, subnet Network mask, Gateway, and Metric.
5 Click
OK.
6 Close the Routing and Remote Access dialog to return to the Management Console.
Note: When you are configuring for a demand-dial modem connection, you must create a static
route for each modem connection to the ISP/headquarters because it is not part of a larger
network. If you know the IP address of a remote office, you can put it in the static routing table.
You will typically create a default static route (IP address 0.0.0.0, subnet 0.0.0.0, and an
appropriate gateway address) to be used as a last resort for packets that Wave does not know
where to send. When you are configuring a static route for a digital connection, you must enter
the gateway address, which is the IP address for the router on the other side of the digital
connection, sometimes called the far end or next hop router. If you configure a gateway address,
you will set up a default static route to that gateway.
Release 2.0
September 2010