Installation guide

Configuring network services and routing protocols 21-6
Chapter 21: Advanced Data Networking Configuration
Wave Global Administrator Guide
3 Select each interface on which you want to enable the routing protocol.
Right-click OSPF in the IP Routing folder and select
New Interface. Select the desired
interface, then click
OK. Configure the Internet properties for that interface on the dialog
that opens, then click
OK.
Note: If the interface you want to add is not show in the Select Interface dialog, add it to the
Summary by choosing Add Routing Protocol from the Actions menu.
4 Close the Routing and Remote Access dialog to return to the Management Console.
Configuring the Wave Server as a network services client
The Wave Server cannot be a client to a DHCP server, as each Wave LAN network
interface/routing port must use a static IP address.
Refer to the following topics for detailed information:
• Configuring the Wave Server as a DNS client
• Configuring the Wave Server as a WINS client
• IP addressing
Configuring the Wave Server as a DNS client
Note: Make sure the Wave Server has a valid static IP address.
To configure your Wave Server as a DNS client
1 If necessary, click the Administration tab of the Management Console.
2 Click the IP Network Settings icon, located in the Data Administration section.
Click
Release 2.0
September 2010