Installation guide

Configuring network services and routing protocols 21-5
Chapter 21: Advanced Data Networking Configuration
Wave Global Administrator Guide
Note: If you are routing across a WAN, be sure to configure the WAN interface on the
Integrated Services Card with RIP. Auto-static, static, and default routing can be used with
demand-dial interfaces. Auto-static makes static routing table entries, and is used only for
demand-dial connections, and only with other Wave Servers or with a remote Microsoft
Windows server acting as a router. Periodic polling will keep a line up all the time, and should
be used only with persistent connections.
Configuring the open shortest path first (OSPF) routing protocol
To configure OSPF
1 Start the Microsoft RRAS applet under Data Administration on the General Administration
tab of the Management Console. Log on using your Wave username and password. The
Routing and Remote Access dialog opens.
For more information about logging in with a remote connection, see “Remote access
applets” on page 2-7.
2 Add the OSPF protocol.
Right-click the General folder under IP Routing, and choose
New Routing Protocol. In the
New Routing Protocol dialog, click “Open Shortest Path First (OSPF)” and click
OK.
Click
Release 2.0
September 2010