Installation guide

Wave Global Administrator Guide
Chapter 21
21. Advanced Data Networking Configuration
CHAPTER CONTENTS
Caution: The settings described in this chapter are expert settings that should not be
modified unless you are instructed to do so by your Vertical Technical Support
representative.
Configuring dial-up routing
When configuring dial-up routing, you will typically configure the parameters only once, when
you install and configure Vertical Wave the first time. If you change ISP providers or access
numbers, you may need to modify these settings.
Configuring dial-up routing requires you to configure demand-dial interfaces. To configure
demand-dial interfaces, you must create an entry for each remote location (ISP, headquarters,
another sales office) to which you want to dial out. The RRAS administrator stores the settings
needed to connect to a particular remote router or network in a “phone book entry.” Once an
interface is configured in RRAS, it acts like any server.
Note: When configuring an internal modem for dial-out routing, you cannot configure the
modem to dial digits following the connection of the call. For example, you cannot configure
an internal modem to dial a number, delay, and then dial more digits.
Configuring dial-up routing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21-1
Configuring network services and routing protocols. . . . . . . . . . . . . . . . . . . . . 21-3
Release 2.0
September 2010