Installation guide

Using the User/Group Management applet 2-14
Chapter 2: Navigating the Management Console
Wave Global Administrator Guide
Accessing the User/Group Management applet
To access the User/Group Management applet
1 From the Wave Global Administrator Management Console, click the User/Group
Management
icon, located in the PBX Administration section.
2 A remote access session opens, connecting you to the Vertical Wave Global Administrator
Log On dialog, with your Wave ISM logon credentials already entered.
If your name and password do not appear, enter them.
Note: A username called “Admin” exists by default, with a password of 100. To create other
administrators, you must add users and give them Global Administrator permissions (see
“The Security \ Permissions tab” on page 11-84).
3 Do one of the following:
• Enter your phone’s
Station ID. To do so, press *00 on your telephone to retrieve your
station ID, and then enter that number. You must enter your station ID if you will need
to record an auto attendant prompt or user voice title using the audio controls. (See
“Using the audio controls” on page 2-20.)
• Leave
Station ID set to 0 if you do not need to use the audio controls. The audio
controls will be disabled in the various User/Group Management applet views.
4 Click
OK. The User/Group Management applet opens.
Note: Leaving the Admin user password as 100 is a security risk that can cost your company
money due to toll fraud. For more information about system security, see Appendix A.
Click
Release 2.0
September 2010