Installation guide

Configuring system-wide ISDN settings 17-12
Chapter 17: Advanced Trunk and Channel Configuration
Wave Global Administrator Guide
4 Click the Value field of the timer that you want to edit. A text box opens where you can
type a new value.
5 Enter a new value for the timer.
For information about specific analog trunk timers, refer to the tables in “Analog trunk
timing values” on page 34-9.
6 If you are using Loop Start signaling, you can specify the
Wait for Dial Tone setting by
selecting or deselecting that check box.
This check box indicates whether Wave should expect a dial tone on the channel before
dialing.
7 If you are using Loop Start signaling, select the
Wait for Caller ID check box if you want to
specify that the trunk should wait one ring for Caller ID information on an inbound call and
answer on the second ring. (Caller ID information will come between the first and second
rings.)
8 Click
Apply to save your changes.
9 Click
Done to return to the Management Console.
Configuring system-wide ISDN settings
System-wide ISDN settings enable you to specify company-wide information about your ISDN
channels, including how long-distance and international calls are dialed when using ISDN.
To set system-wide ISDN settings
1 If necessary, click the Administration tab of the Management Console.
2 Click the General Settings icon, located in the General Administration section.
Click
Release 2.0
September 2010