Installation guide

Setting trunk timing values 17-9
Chapter 17: Advanced Trunk and Channel Configuration
Wave Global Administrator Guide
5 Click the Value field of the timer that you want to edit. A text box opens where you can
type a new value.
6 If the channel or channels you are editing are configured for Ground Start signaling, you
can modify the
Wait For Dial Tone setting by selecting or deselecting that check box.
This check box tells Wave whether or not to expect dial tone on the channel before dialing.
7 Click
Apply to save your changes.
8 Click
Done to return to the Management Console.
Setting analog trunk timing values
Caution: These are expert settings that should not be modified unless you are
instructed to do so by your Vertical Technical Support representative.
To set the timing values an analog trunks
1 If necessary, click the Administration tab of the Management Console.
2 Click the Trunk Configuration icon, located in the Trunk Administration section.
Click
Release 2.0
September 2010