Installation guide

Configuring System Speed Dial 16-34
Chapter 16: PBX Feature Configuration
Wave Global Administrator Guide
4 Enter a five-digit password in the Enter New Password field.
5 Enter the password again in the
Confirm Password field.
6 Click
OK.
7 Click
Apply to save your changes.
8 Click
Done to return to the Management Console.
Adding speed dial numbers using the phone
To add a speed dial number using the phone
1 From any Wave phone, dial *88.
2 Enter the following in sequence:
•
5-digit System Speed Dial password. The default password is 11111.
•
3-digit speed dial index number. You can enter any number in the range 000-999.
•
Phone number. A phone number can be any digit sequence up to 32 digits in length.
Include the trunk access code (for example, 9) for external calls.
3 Press # to save the number.
For example, using the following format:
*88 + [password] + [index] + [phone number] + #
You might enter:
*88 12345 123 914085551212 #
This example creates the system speed dial number “123” that automatically dials 9 for
external access and then the number 1-408-555-1212.
• If the password you entered is correct, Wave responds with two beeps indicating that
the speed dial number was created. The new number overwrites any number
previously stored at that index.
• If the password is incorrect, Wave responds with a fast-busy tone.
A default description is created in Wave’s System Speed Dial table based on the extension
number from which the speed dial number was added. After adding a speed dial number
using the phone, you can open the System Speed Dial applet to view and edit the default
description. See “Adding speed dial numbers” on page 16-31.
Release 2.0
September 2010