Installation guide

Configuring System Speed Dial 16-33
Chapter 16: PBX Feature Configuration
Wave Global Administrator Guide
5 Enter the speed dial number in the Index field.
The
Index field is automatically filled in with the next available index number. You can
enter any number in the range 000-999.
6 Enter the phone number in the
Telephone # field.
A phone number can be any digit sequence up to 32 digits in length. Be sure to include the
external access code if necessary.
Note: Phone numbers for external calls must include the first digit defined in the First Digit
Table applet for external dialing access. These external speed dial numbers can be dialed
using primary lines, secondary line appearances, and outside lines.
7 Enter a
Description for the speed dial number. The description can be any character
sequence up to 20 characters in length.
8 Click
OK to close the Add New Index dialog.
9 Click
Apply to save your changes.
10 Click
Done to return to the Management Console.
Setting the System Speed Dial password
The System Speed Dial password is used when you add a system speed dial number using the
phone as described in “Adding speed dial numbers using the phone” on page 16-34. By default,
the system speed dial password is set to 11111.
To set the System Speed Dial password
1 If necessary, click the Administration tab of the Management Console.
2 Click the System Speed Dial icon, located in the PBX Administration section.
3 Click
Change Password.
Click
Release 2.0
September 2010