Installation guide

Configuring Night Answer 16-30
Chapter 16: PBX Feature Configuration
Wave Global Administrator Guide
4 Enter a destination in the Default Night Answer Destination field.
5 Edit your inbound trunk groups’ Inbound Routing Tables to specify the correct night
answer mode in the Night Answer Mode field.
• If you are configuring your incoming T-1 or analog trunks for Night Answer, open the
Trunk Groups applet and edit your Inbound Routing Tables.
• If you are configuring your incoming IP Telephony calls for Night Answer, open the
IP Telephony applet, select Default Inbound Routing from the Call Routing folder,
and click the
Edit Inbound Routing Table button.
The available Night Answer Modes are as follows:
•
Not Used. Disables the Night Answer Mode for this trunk group
•
Use System Default. Uses the Default Night Answer Destination specified in the
General Settings applet
Note: Select an Access Profile for Tandem Calls in the Inbound Trunk Group dialog
and enable Allow Trunk-to-Trunk Connections in the General Settings (PBX
(Advanced) tab) if the Default Night Answer Destination you specified in General
Settings is an off-premise call and not routed using the Global Access outbound
routing rules.
•
User Defined. Uses the destination that you enter in the Night Answer Destination
field in the Inbound Routing Table and it overrides the system default specified in the
General Settings applet
Note: Select an Access Profile for Tandem Calls in the Inbound Trunk Group dialog
and enable Allow Trunk-to-Trunk Connections in the General Settings (PBX
(Advanced) tab) if the Night Answer Destination you specified is an off-premise call
and not routed using the Global Access outbound routing rules.
Note: The night answer mode configuration is not allowed for the Modem trunk group.
Release 2.0
September 2010