Installation guide

Configuring Night Answer 16-29
Chapter 16: PBX Feature Configuration
Wave Global Administrator Guide
3 In the PBX (Advanced tab) of the General Settings applet, in the Dialing section select the
Enable Call Return ___ Trunk Access Code (TAC) check box.
4 Enter the trunk or external access code required to make an external call, typically 9.
5 Click
Apply to save your changes.
6 Click
Done to return to the Management Console.
Configuring Night Answer
The Night Answer feature enables you to manually place the Wave Server into a mode where
inbound calls are redirected to predetermined destinations. You can configure any extension or
external phone number as the destination.
To put the Wave Server in or out of Night Answer mode
• On digital phones, configure a Night Answer button to activate and deactivate Night
Answer. When Night Answer is active, the LED flashes red. When Night Answer is not
active, the LED is dark.
• On phones without a Night Answer button, dial
*85 to activate Night Answer and *86 to
deactivate Night Answer.
To configure Night Answer
1 If necessary, click the Administration tab of the Management Console.
2 Click the General Settings icon, located in the General Administration section.
3 In the PBX tab of the General Settings applet, select the
Night Answer Mode check box.
Click
Release 2.0
September 2010