Installation guide

Enabling call return for external calls 16-28
Chapter 16: PBX Feature Configuration
Wave Global Administrator Guide
To enable DSS/BLF updates when a user’s phone is active on any line
1 If necessary, click the Administration tab of the Management Console.
2 Click the General Settings icon, located in the General Administration section.
3 In the PBX tab of the General Settings applet, select the
Enable DSS/BLF updates when the
user’s phone is active on any line
check box.
4 Click
Apply to save your changes.
5 Click
Done to return to the Management Console.
Note: This option is enabled or disabled on a global basis for all users.
Enabling call return for external calls
This option allows a user to automatically call back the last inbound external call via the *69
phone command or a phone feature button configured for Call Return. If this option is not
enabled, users cannot automatically call back external calls. The Trunk Access Code (TAC) that
you specify according to the following steps is prepended to the phone number of most recent
inbound external call before the call is returned.
To enable call return for external calls
1 If necessary, click the Administration tab of the Management Console.
2 Click the General Settings icon, located in the General Administration section.
Click
Click
Release 2.0
September 2010