Installation guide

Enabling DSS/BLF updates when the user’s phone is active on any line 16-27
Chapter 16: PBX Feature Configuration
Wave Global Administrator Guide
To configure automatic phone relocation
1 If necessary, click the Administration tab of the Management Console.
2 Click the General Settings icon, located in the General Administration section.
3 In the PBX tab of the General Settings applet, select the
Allow Automatic Phone Relocation
check box.
4 Click
Apply to save your changes.
5 Click
Done to return to the Management Console.
Enabling DSS/BLF updates when the user’s phone is active on any line
A Direct Station Select/Busy Lamp Field (DSS/BLF) feature button on a digital phone monitors
the state of a specific extension, and provides a quick way for a user to place or transfer a call
to that extension. A DSS/BLF feature button can be in one of the following states:
• A solid red LED next to a DSS/BLF button indicates that the extension is in use.
• A flickering red LED indicates the extension is ringing.
• A blinking LED indicates that the extension has a call on hold, or the extension is in Do
Not Disturb mode.
By default, the DSS/BLF feature button only reflects the state of the assigned extension's
primary line. When you perform the steps described below, a DSS/BLF feature button on a
user’s digital phone will reflect the assigned extension’s state for any line, not just the
extension’s primary line. For example, if the user at extension 201 is busy on an Outside Line
or on a line appearance, another user with a DSS/BLF feature button assigned to extension 201
will see that the user is busy on a call.
Click
Release 2.0
September 2010