Installation guide

Enabling automatic phone relocation 16-25
Chapter 16: PBX Feature Configuration
Wave Global Administrator Guide
4 Select the Enable Public Address check box.
Once Public Address is enabled, users can make announcements over the public address system
and digital phone speakers by pressing the System Page button on digital phones, or dialing
*11.
For more information about the System Page feature, see “Page feature” on page 10-26.
Enabling automatic phone relocation
When automatic phone relocation is enabled on the Wave Server, a previously-working digital
phone will be recognized after it has been unplugged and moved to a new location, for example
if a user switches offices. You do not need to manually reassign the phone’s extension or
reprogram feature buttons after a move.
Automatic phone relocation supports two methods of phone relocation, depending on the digital
phone type:
•
Auto recognition is supported only on Comdial digital phones (Edge100, 80xx, and
83xx).
Comdial digital phones store the extension assigned when the phone last came into
service. When a previously-working Comdial digital phone is plugged in at the new
location, the user is asked if he or she wishes to retain the extension assigned to the phone.
• If the user responds YES, all phone-specific information—programmed feature
buttons, speed dial numbers, and so forth—is retained at the new location.
• If the user responds NO (or if the user lets the question time out after about 2
minutes),
*98 must be used for automatic phone relocation, as described below.
•
Relocation Feature Code *98 is supported on all digital phones, including those listed
above. Dialing
*98 + an extension on a digital phone assigns that extension to the phone.
The extension to be assigned cannot currently be in service.
Release 2.0
September 2010