Installation guide

Configuring Music On Hold 16-17
Chapter 16: PBX Feature Configuration
Wave Global Administrator Guide
To configure a system port for music on hold
1 If necessary, click the Administration tab of the Management Console.
2 Click the Resource Management icon, located in the PBX Administration section
3 Expand the Application Resources folder.
4 Expand the Music On Hold folder, and then select
Wave Player.
5 Select a port from the
Wave Player drop-down list.
6 Click
Apply to save your changes, and click Done to close the Resource Management
applet.
To enable system-wide music on hold
1 If necessary, click the Administration tab of the Management Console.
2 Click the General Settings icon, located in the General Administration section.
Click
Click
Release 2.0
September 2010