Installation guide

Configuring dialing time-out 16-13
Chapter 16: PBX Feature Configuration
Wave Global Administrator Guide
Configuring dialing time-out
Configure the settings that determine how long Wave should wait after you finish dialing before
placing the call.
In the General Setting applet, PBX (Advanced) tab, in the Dialing section set
When dialing, wait
up to ___ seconds for next digit to be entered
. This drop-down list sets the dialing timeout. If
the specified time elapses before another digit is pressed, Wave will stop collecting digits and
attempt to route the call based on the digits collected.
The dialing timeout is useful for dialing numbers of a length not expected by your dialing plan.
For example, in North America, numbers are generally 7, 10, or 11 digits in length. If you are
dialing an international number the length of the number will be longer than expected, or if you
are dialing the local operator the number will be shorter. After you have finished dialing the
number, Wave will wait the number of seconds specified in the drop-down list, and place the
call as dialed.
Requiring an access code for emergency number dialing
In order to help prevent accidental emergency calls, Wave is configured by default to require
users to dial an external access code before dialing an emergency number.
Important: If you require an external access code to dial an emergency number, be sure that all
users know about this requirement, and that they know the access code to use.
Click
Release 2.0
September 2010