Installation guide

Configuring Caller ID 16-11
Chapter 16: PBX Feature Configuration
Wave Global Administrator Guide
Use this setting to provide the station name and phone number on outbound calls.
Note: If this setting is your choice, it is generally recommended that you set this at the
system-wide level in the General Settings applet.
•
Do Not Send Caller ID. Sends no external Caller ID from this trunk group or IP call
destination.
Use this setting for trunks that do not support Caller ID, or for trunks where you want
to block external Caller ID.
Configuring system-wide Caller ID settings
Configure the system-wide Caller ID settings for calls initiated by internal extensions in the
General Settings applet. Remember that the external Caller ID is only sent to the central office
if the trunk group is configured to send external Caller ID.
To configure system-wide Caller ID settings
1 In the General Settings applet on the System tab, if you have not already done so enter the
Company Name and Company Main Number.
Note: While Company Name can include up to 16 alphanumeric characters, Caller ID
cannot send more than 15 characters over ISDN.
On the PBX tab, select a default External Caller ID setting for calls initiated by stations.
Select one of the following options:
Release 2.0
September 2010