Installation guide

Backing up your system configuration 15-4
Chapter 15: Initial System Administration
Wave Global Administrator Guide
Note the following:
• If a WaveNet node was not currently added to the WaveNet network at any time before or
after performing a backup, restoring the system configuration on that node does not
physically re-add the restored node to the WaveNet network.
• If a WaveNet node was not currently added to the WaveNet network when the backup
was performed, but was added before the restore is performed, the restored node will not
be re-added to the WaveNet network after the restore. To re-add the restored node to the
network, from any node in the network perform the steps in “Adding a Wave Server to
the WaveNet network” on page 25-14.
In this case, publications from the other nodes to the restored node will be re-established,
but publications from the restored node will have to be re-built manually, because they
were not included in the backup.
Backing up your system configuration
To back up your system configuration
1 If necessary, click the Administration tab of the Management Console.
2 Click the System Backup/Restore icon, located in the General Administration section.
Click
Release 2.0
September 2010