Installation guide

Wave Global Administrator Guide
Chapter 14
14. Data Networking Configuration
CHAPTER CONTENTS
Before you can configure your Vertical Wave Server to connect to the Internet, you must have
already configured your analog and digital trunks. (See Chapter 5, Configuring Analog and
Digital Trunks..)
Ensuring that the T-1 serial interface is set correctly
When you connect an external router to your Wave Server’s T-1 module with a serial interface,
you must:
• Assign channels of the T-1 trunk to the serial interface (see “Assigning digital channels to
a serial interface” on page 5-35 for details)
• Ensure the serial interface is set correctly
Typically, you will not need to change the interface settings unless you have a non-standard
configuration.
To ensure that the serial interface is set correctly
1 If necessary, click the Administration tab of the Management Console.
2 Click the Trunk Configuration icon, located in the Trunk Administration section.
Ensuring that the T-1 serial interface is set correctly . . . . . . . . . . . . . . . . . . . . 14-1
Click
Release 2.0
September 2010