Installation guide

Where to start 1-2
Chapter 1: About This Guide
Wave Global Administrator Guide
This guide provides information about all parts of the remote administration interface used to
perform the configuration and system administration steps to set up the Wave system. An
extensive online Help system provides detailed information about additional functionality not
described in this guide.
Note how the following terms are used in this guide:
•“Wave ISM” refers to the Wave software infrastructure, Wave Integrated Services
Manager.
•“Wave Server” refers to the physical server PC on which Wave ISM runs. Most of the
information in this guide applies to all Wave Server models. When information applies to
a specific to a Wave Server model, the model is identified, for example “Wave IP 2500”
or “Wave IP 500”. For more about the different Wave Server models, see the Wave Server
Installation Guide.
•“Wave” refers to your Wave phone system as a whole.
Where to start
This guide includes information for readers at a variety of levels. To get the most out of the
documentation, start by reading the parts that are most relevant to your level of experience.
For new Wave system administrators
1 Begin by reading PART 3, “Key Wave Concepts”
2 Next, work through the procedures in PART 1, “Initial Configuration and Administration”
to configure the basic Wave system settings.
3 Then choose the advanced features you wish to configure from PART 2, “Advanced
Configuration and Administration”.
4 Refer to PART 4, “Reference”, as necessary.
That’s all you need to begin configuring most typical Wave system installations.
Release 2.0
September 2010