Installation guide

The Voice Mail \ E-mail, Pager, and Call Notification tabs 11-40
Chapter 11: Managing Users and Roles
Wave Global Administrator Guide
3 Select whether pager notifications occur, and if so, how often. (See “Determining which
voice messages send notification” on page 11-37.)
4 In the
Page using field, select the dialing service that you want Wave to use to dial the
user’s pager.
5 In the
Dial Sequence field, enter the dial string for the pager, including the phone number
of the paging service and the pager's PIN if required. The dial string can contain any touch
tone digit (0-9, *, #). You can also enter a comma to indicate a 2-second pause in the dial
sequence.
You can also use the following special characters to add information to the page:
• I or i sends the Caller ID number (for an external call) or Wave extension (for an
internal call).
• E or e sends the Wave extension that the caller dialed.
• L or l sends the length of the voice message in seconds.
For example, the dial sequence
18007771000,,,1245983#E causes Wave to dial the paging
service, pause for 6 seconds, enter the pager’s PIN (1245983) followed by # to indicate
end-of-PIN, enter your extension (where the voice message was left), and then hang up. In this
example, your pager displays only the extension number.
If users receive only the last portion of the pager data specified, there are not enough pauses
between the pager number and the information. If this problem occurs, add more commas (each
of which represents a 2-second pause.)
Note: Do not enter multiple stars (*) in a row in the pager string. Use only one star to send a
dash. Multiple consecutive stars can terminate the page message.
Release 2.0
September 2010