Installation guide

The Voice Mail tab 11-33
Chapter 11: Managing Users and Roles
Wave Global Administrator Guide
7 Enter the following information:
•
Domain. Domain for user accounts on the Exchange Server, for example
“mycompany.com”.
•
URI. Uniform Resource Indicator for Wave Mail to use to connect to the Exchange
Server, for example:
https://mail.mycompany.com/EWS/exchange.asmx
•
Impersonation Account. User name for the Exchange impersonation user account
used by Wave Mail to synchronize with all other Exchange accounts on the Exchange
Server. You specified this user name (and the following password) when you created
the impersonation user account in “Configuring your e-mail provider for Wave Mail”
on page 11-30
•
Impersonation Password. Password for the Exchange impersonation account used by
Wave Mail.
8 Select the
Provider Enabled checkbox to enable Wave Mail synchronization on this e-mail
provider. One or more e-mail providers can be enabled at the same time. If this checkbox is
not selected, synchronization on any Wave Mail mailboxes defined for this provider does
not occur.
9 Click
Test to verify that Wave Mail can successfully communicate with the Exchange
Server as configured with the current settings. If the test fails, Wave Mail mailboxes on that
e-mail provider will not be synchronized until the problem is resolved.
Possible causes for failure include:
• Invalid domain or URL
• Impersonation account was not created correctly
• Incorrect Impersonation account name or password
10 .When the new e-mail provider configuration is working correctly, click
OK.
After you complete these tasks, go to the next section.
Release 2.0
September 2010