Installation guide

Configuring digital and SIP phone feature buttons 10-39
Chapter 10: Configuring Phones
Wave Global Administrator Guide
• The following behavior, which occurs on all digital phone models, may be confusing to
users:
•
If a user does not have a forwarding number set up via the User/Group
Management applet
(User dialog, Phone \ Call Handling tab), when that user
presses the User Forward button on his or her digital phone and enters a forwarding
number, the button’s LED flashes red until the user presses the User Forward button
again to cancel call forwarding.
•
If a user does have a forwarding number set up via the User/Group Management
applet
, the user may observe either of the following:
When that user presses the User Forward button on his or her phone and enters a
forwarding number that matches the number set up set up via the User/Group
Management applet, the button’s LED displays solid red until the user presses the
User Forward button again to cancel call forwarding.
When that user presses the User Forward button on his or her phone to enter a
forwarding number that is different from the number set up via the User/Group
Management applet, the button’s LED remains off.
Voice Call feature
Intercom page directed to a specific phone extension. You can include multiple Voice Call
buttons on a phone.
Phone type: Digital, SIP.
Required settings: None.
Optional settings:
•
Extension. Any valid extension number. If you leave this field blank, the user can
program the button or dial an extension from the phone.
Release 2.0
September 2010